|
 The basic package
includes all metal parts need to build the foam cutter. Parts are laser cut
and powder coated. A detailed manual explains in step by step
instructions how to assemble and test each part made.
Included in the basic package:
* All metal parts
* All Teflon Bushings.
* Detailed manual.
* No drilling or tapping is required.
* Shafts, motors and ACME screws are not included.
* Parts are designed for NEMA23 motors.
|
|
The Basic Plus Package - $750
|
|
|
The basic plus package
includes all the metal parts and shafts needed to build the
the foam cutter. Parts are laser cut and powder coated.
Shafts are cut to length and tapped on both ends. ACME
screws are machined down to 1/4" on one end to fit into
the motor coupler. A detailed manual explains in step by step
instructions how to assemble and test each part.
Included in the Basic Plus package:
* All metal parts
* All Teflon Bushings.
* 4 ACETAL ACME nuts with their mounting screws.
 |
4 X Axis shafts
4 Y Axis shafts
2 Y Axis ACME screws
2 X Axis ACME screws |
| *
4 ACME screws are machined at its end to 1/4" |
|
*
Detailed manual.
* No drilling or tapping is required.
* 15" travel on the horizontal axis.
* 9" travel on the vertical axis.
* Electronics, motors and hot wire are not
included
|
|
|
|
Who should buy the basic
package?
The basic package is priced to enable you to build your own machine.
The parts can be converted to a CNC router table
or any other linear
slide design you may have.
If you want to make the machine larger, smaller, of different then the
one we designed, the basic package may also be right for you.
No taping, drilling is required at any
step is the assembly
What will you have to add for a full blown foam cutter?
* Shafts
for the X axis and the Y axis.
* ACME
screws and nuts for both axis
* 4
Stepper motors and cables.
* Stepper
motor driver board.
* Power
supply for the driver board.
* Hot
wire power supply.
* Hot
wire
* Software
What software should I use ?
For cutting wings, Foamwork available
at www.foamwork.net.
Or any other software that has control over the parallel port.
Other software that can be used:
Mach3, DeskCNC, KCAM...
What are the step motor specs ?
Motors are Bipolar motors.
2A 3V with about 120Oz/Inch - or similar.
|
