|
|
 |
|
Full Package - 15" x 9" - $1500 |
 |
The Full package includes everything you need to build the Hot
Wire CNC foam cutter. Hot wire power
Supply and hot wire are not included
No Soldering, drilling or tapping is required
Assembly time is usually less then two hours
Includes:
All Mechanical parts, shafts, ACME screws, ACME nuts, bearing,
mounting brackets, stepper motor driver board, power
supply, cables, motors and motor couplers
Specs:
Effective
Horizontal travel: 15"
Effective
Vertical travel: 9"
Axis: 4 independent axis (will cut tapered wings).
4800 steps per inch
Electronics: 4 axis pulse and direction on Printer port.
Motors: NEMA23 2.8A 3.3V
Power: 110V 200W.
Cutting Speed: Software dependent - up to 20"/min
Resolution: 4800 steps per inch.
Software is available at
www.devcad.com or
here
Mach3 from www.machsupport.com
will run the cutter
** Electronic board is fully assembled and tested
** No soldering required
** Wire length is dependent on the hot wire power
supply voltage |
|
|
4 X Axis shafts 1/2" - tapped on both ends
4 Y Axis shafts 1/2" - tapped on both ends
2 Y Axis ACME screws 3/8-12 - Machined to 1/4" one one end
2 X Axis ACME screws 3/8-12 - Machined to 1/4" one
one end |
 |
4 Axis
electronic board (assembled and tested)
4 Stepper Motors with 4 cables.
Power supply for the electronic board. (110V or
220V)
PC to board D25 cable
Power cable for power supply
Software: Will work with Mach3 and DevCAD
Assembly
Manual |
|
|
Not
Included: Electronics case, hot wire power supply
and hot wire |
|
|
Pro Package - 22" x 15" x 40" - $2500
|
|
|
|
|
|
|
|
